All Member Forum

 View Only

  • 1.  Additive to Poly Pro

    Posted 01-02-2024 06:24 PM
    Hi Everyone, 
    I make a pakage out of Poly Pro, and I'm looking for an additive, or other soultion to make the Poly Pro less prone to getting sticky when in contat with Cannabis flower. Any suggestions on addative or proscess?

    Thank you very much!

    --
    Thank you, 
    Chason Sordoni, COO
    610-357-6678



    Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message. Thank you.


  • 2.  RE: Additive to Poly Pro

    Posted 01-04-2024 07:57 PM
    Good day, Chason.

    Have you tried using an Anti-Stat additive to prevent the cannabis flower particles from positively clinging to the plastic?

    Give this a try.

    All the best,

    Albert Friedman
    Ashland Container Corp
    678-296-6105




  • 3.  RE: Additive to Poly Pro

    Posted 01-05-2024 04:41 PM
    Alberto, 
    Thank you for taking the time to answer. 
    We are investigating this - is there anyone you can recommend?

    Best, 
    Chason 




    Original Message


  • 4.  RE: Additive to Poly Pro

    Posted 01-06-2024 06:21 AM
    Good day, Chason.

    I would suggest speaking with your current polypropylene resin supplier for their anti-stat recommendations, but one additive that comes to mind is made by BASF: Larostat 264A.

    Best of luck with this.

    Albert Friedman
    Ashland Container Corp
    678-296-6105


    Original Message


Related Content